Shah Red Rouge Polishing Compound 50G Silversmithing Jewellery For Gold Copper 
Repousse Hammer Chasing Hammer 25.4 Mm 1 Inch Head Face Jeweller Jewellery 
Flat Sided Wax Tube Green 33.3 Mm High X 30.2 Mm Wide 
Jeweller Pickle Remove Firestain Safety Pickling Copper Oxide Remover Jewellery 
Shah Stone Replacement For Water Of Ayr Stone Polishing Jewellery For Jewellers 
Parallel Pliers 125Mm Maun Flat Nose Pliers Smooth Jaws Made In England 
Silver Easy Grade Solder For Jewellery & Silversmithing Jewellers Hallmarking 
Solder Kit Starter Kit Jewellery Torch, Charcoal Crucible, Soldering Brick 
Radial Bristle Brush Abrasive With Mandrel Pendant Wheel Jewellery Grit: 
925 Silver Wire Sterling 0.2Mm - 3Mm Round Wire Silver Wire Making Jewellery 
Wet And Dry Cloth Sandpaper Grades 1500, 2400, 4000, 6000, 8000, 12000 Finest 
Riveting Hammer Used By Jewellers And Silversmiths Not To Mark Jewellery Items 
Repousse And Chasing Hammer With Ball Pein 
Setters Cement For Setting Stones (8 Stick) Shellac Based Cement Stone Setting 
Premium Hard Arkansas Stone Fine 4 Inch X 2 Inch Sharpening Stone In Box Bench 
Steel Dapping Die With Oval, Half Round, Grooves Doming For Forming Jewellery 
2 X Borax Cone Flux
£26.99
10 in stock
Free shipping on orders over £50!
- Satisfaction Guaranteed
- No Hassle Refunds
- Secure Payments
Description
2 x Borax Cone Flux used in soldering silver and gold jewellery, Dry form used with Borax Dish STS
2 x Borax Cone
Used with water and a Borax Dish to form a paste
Jewellers Flux for Soldering silver, copper
Flux is needed when you solder using silver solder
Please note the borax dish is sold separately
Borax cones are a dry form of flux. Used with water and a Borax Dish to form a paste. The amount of water required is minimal – wet surface of the dish and tip out excess – what remains is sufficient. What you are trying to aim for is a toothpaste consistency. Move the cone in a circular motion (whilst applying a little pressure) in one area of the dish. Due to the ceramic texture fine deposits of the cone are left in the water and in turn form a paste. The paste is then used as a flux to keep the joining area clean while soldering.
Reviews
There are no reviews yet.