Flat Sided Wax Tube 25Mm Wide X 28Mm High Blue 
Solder Kit Starter Kit Soldering Jewellery Torch, Plier, Flux, Ring Clamp, 
Flat Sided Wax Tube Green 33.3 Mm High X 30.2 Mm Wide 
Vallorbe Glardon Piercing Saw Frame Adjustable For Jewellery And Silversmithing 
Charcoal Block For Soldering Jewellery Work Charcoal Brick Circle Silver 
Bearing Hart Cutting Burr Bur Setting Stones Gems Jeweler Jewellery 0.9Mm To 
Parallel Pliers 125Mm Maun Flat Nose Pliers Smooth Jaws Made In England 
Flat And Round Jaw Pliers For Shaping 
Wet And Dry Cloth Sandpaper Grades 1500, 2400, 4000, 6000, 8000, 12000 Finest 
925 Silver Wire Sterling 0.2Mm - 3Mm Round Wire Silver Wire Making Jewellery 
Green Opal Stone Quaver Shaped 
Premium Hard Arkansas Stone Fine 6 Inch X 2 Inch Sharpening Stone In Box Bench 
Jeweller Pickle Remove Firestain Safety Pickling Copper Oxide Remover Jewellery 
Soldering Torch 
Engraving Cement Jewellery Engraver Cement Jewellers Silversmiths Setter Cement 
Solder Kit Starter Kit Soldering Jewellery Includes Torch, Flux, Hammer, Solder 
Satinising Cylinder Burr Bur Gives Satin Finish 7Mm Coarse Grade To Jewellery 
Shah Stone Replacement For Water Of Ayr Stone For Jeweller And Silversmiths 
Felt Bangle Buffs For Polishing Inside Of Bangles For Jewellers 
Shah Finesse Finish Polishing Compound 50G For Polishing Silver, Gold, Copper 
Felt Wheel Buff For Cleaning Jewellery Pendant Wheel Polishing 2.35Mm Shank 
Dome Anvil Fretz Bench Anvil For Jewellery Making Forming High Dome Jeweller 
Borax Cone Flux
£14.99
10 in stock
Free shipping on orders over £50!
- Satisfaction Guaranteed
- No Hassle Refunds
- Secure Payments
Description
Borax Cone Flux used in soldering silver and gold jewellery, Dry form used with Borax Dish
Borax Cone
Used with water and a Borax Dish to form a paste
Jewellers Flux for Soldering silver, copper
Flux is needed when you solder using silver solder
PLEASE NOTE, BORAX DISH IS SOLD SEPARATELY
Borax cones are a dry form of flux. Used with water and a Borax Dish to form a paste. The amount of water required is minimal – wet surface of the dish and tip out excess – what remains is sufficient. What you are trying to aim for is a toothpaste consistency. Move the cone in a circular motion (whilst applying a little pressure) in one area of the dish. Due to the ceramic texture fine deposits of the cone are left in the water and in turn form a paste. The paste is then used as a flux to keep the joining area clean while soldering.
Reviews
There are no reviews yet.